Owner's Manual

136 Ethernet Configuration Commands
www.dell.com | support.dell.com
Example
In the following example, automatic crossover is enabled on g5.
back-pressure
The back-pressure interface configuration command enables Back Pressure on a given interface. To
disable Back Pressure, use the
no form of this command.
Syntax
back-pressure
no back-pressure
Default Configuration
Back Pressure is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
Back Pressure will operate only if duplex mode is set to half.
Example
In the following example Back Pressure is enabled on g5.
port jumbo-frame
The port jumbo-frame global configuration command enables jumbo frames for the device. To
disable jumbo frames, use the
no form of this command.
Syntax
port jumbo-frame
no port jumbo-frame
Default Configuration
Jumbo Frames are not enabled.
Console(config)# interface ethernet g5
Console(config-if)# mdix auto
Console(config)# interface ethernet g5
Console(config-if)# back-pressure