Owner's Manual
142 Ethernet Configuration Commands
www.dell.com | support.dell.com
The displayed port status information includes the following:
•
Port
—The port number.
•
Description
—If the port has a description, the description is displayed.
•
Port Type
—The port designated IEEE shorthand identifier. For example, 1000Base-T refers to
1000 Mbps baseband signaling inluding both Tx and Rx transmissions.
•
Duplex
—Displays the port Duplex status.
•
Speed
—Refers to the port speed.
•
Neg
—Describes the Auto-negotiation status.
•
Flow Control
—Displays the Flow Control status.
•
Back Pressure—
Displays the Back Pressure status.
•
Link State
—Displays the Link Aggregation status.
show interfaces description
The
show interfaces description
user
EXEC command displays the description for all configured
interfaces.
Syntax
show interfaces description [ethernet interface
|
port-channel
port-channel-number
|
oob-
eth
oob-interface
]
•
interface—
Valid Ethernet port.
•
port-channel-number
—A valid port-channel trunk index.
•
oob-interface
—Out-of-Band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Modes
Privilege EXEC mode
User Guidelines
There are no user guidelines for this command.