Owner's Manual

146 Ethernet Configuration Commands
www.dell.com | support.dell.com
show ports jumbo-frame
The show ports jumbo-frame user EXEC command displays the jumbo frames configuration.
show ports jumbo-frame
Default Configuration
This command has no default configuration.
Command Modes
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the jumbo frames configuration.
Single Collision Frames Counted frames that are involved in a single collision, and are
subsequently transmitted successfully.
Late Collisions Counted times that a collision is detected later than one slotTime into
the transmission of a packet.
Excessive Collisions Counted frames for which transmission fails due to excessive collisions.
Internal MAC Tx Errors Counted frames for which transmission fails due to an internal MAC
sublayer transmit error.
Oversize Packets Counted frames received that exceed the maximum permitted frame
size.
Internal MAC Rx Errors Counted frames for which reception fails due to an internal MAC
sublayer receive error.
Received Pause Frames Counted MAC Control frames received with an opcode indicating the
PAUSE operation.
Transmitted Pause Frames Counted MAC Control frames transmitted on this interface with an
opcode indicating the PAUSE operation.
Console# show ports jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset