Owner's Manual

252 OSPF Commands
www.dell.com | support.dell.com
show ip ospf
The show ip ospf user EXEC command displays general OSPF routing information.
Syntax
show ip ospf
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures authentication login.
The following table describes the fields that display:
Console# show ip ospf
OSPF is enabled
OSPF Router ID 192.42.110.200
Supports only single TOS(TOS0) route
It is an area border and autonomous system boundary router
Redistributing External Routes from,
rip with metric mapped to type 2
Number of areas in this router is 3
Area 192.42.110.0
Area is a stub area with default cost 10
Number of interfaces in this area is 1
SPF algorithm executed 6 times
Field Description
OSPF Router ID OSPF router ID.
Supports... Number of types of service supported (Type 0 only).