Owner's Manual

28 Command Groups
www.dell.com | support.dell.com
ACL Commands
Address Table Commands
Command Group Description Mode
ip access-list Creates IP ACLs, and enters to IP-
Access list configuration mode.
GC
permit (IP) Allows traffic if the conditions
defined in the permit statement
are matched.
IP
deny (IP) Denies traffic if the conditions
define in the deny statement are
matched
IP
mac access-list Creates Layer 2 MAC ACLs, and
enters to MAC-Access list
configuration mode.
GC
permit (MAC) Allows traffic if the conditions
defined in the permit statement
are matched.
MT
deny (MAC) Allows traffic if the conditions
defined in the permit statement
are matched.
MT
service-acl Applies an access-list to the input
of an interface.
IC
show access-lists Displays access control lists
(ACLs) defined on the switch.
PE
show interfaces access-lists Displays access lists applied on
interfaces.
PE
Command Group Description Mode
bridge address Adds a static MAC-layer station source address to the bridge table. VC
bridge multicast filtering Enables filtering of Multicast addresses. GC
bridge multicast address Registers MAC-layer Multicast addresses to the bridge table, and adds
static ports to the group.
VC
bridge multicast forbidden
address
Forbids adding a specific Multicast address to specific ports. VC
bridge multicast forward-all Enables forwarding of all Multicast packets on a port. VC