Owner's Manual

308 QoS Commands
www.dell.com | support.dell.com
Command Mode
Class-map Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example defines the match criterion as the access-group named "dell". The access-
group is in a class map called "class1".
policy-map
The policy-map global configuration command creates policy maps and enters policy map
configuration mode. To delete a policy map, use the
no form of this command.
Syntax
policy-map policy-map-name
no policy-map policy-map-name
• policy-map-name —Specifies the policy map name.
Default Configuration
The default behavior of the policy map is to set the DSCP value to 0 for IP packets, and to set
the CoS value to 0 if the packet is tagged.
Command Mode
Global Configuration mode
User Guidelines
Before you configure policies for classes whose match criteria are defined in a class map, use
the
policy-map command to specify the name of the policy map to be created, added to, or
modified.
Entering the
policy-map command enables the policy-map configuration mode in which the
class policies for that policy map can be configured or modified.
Class policies can be configured in a policy map only if the classes have defined match
criteria. To configure the match criteria for a class, use the
class-map global configuration and
match class-map configuration commands. Only one policy map per interface per direction is
supported. The same policy map can be applied to multiple interfaces and directions.
Console (config)# class-map class1
Console (config-cmap)# match access-group dell