Owner's Manual

QoS Commands 315
Syntax
service-policy input policy-map-name
no service-policy input policy-map-name
• input policy-map-name —Specifies the policy-map being applied to an input interface.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration mode
User Guidelines
The service-policy interface configuration command cannot be used to attach policy maps
that contain set or trust policy-map class configuration commands or that have access control
list (ACL) classification to an egress interface. The only match criterion supported on an
egress interface is match ip dscp dscp-list. For non-IP Packets, the final CoS is converted to
DSCP for classification purposes. If there is an attempt to apply a policy map on an egress
interface with anything other than the match ip dscp class-map configuration command, an
error message is generated.
NOTE: Only one policy map per interface per direction is supported.
Example
The following example attaches policy map "policy1" to the input interface.
Console (config-if)# service-policy input policy1