Owner's Manual

360 SNMP Commands
www.dell.com | support.dell.com
Example
The following example displays the configuration of filters.
SNMPv1/v2 Commands
snmp-server community
The snmp-server community global configuration command sets up the community access string
to permit access to the SNMP protocol. To remove a community or community group, use the
no
snmp-server community
command.
Syntax
snmp-server community community [ ro | rw | su ] [ ip-address ][ view view-name ] [type {router
| oob}]
snmp-server community-group
community group-name [ ip-address ] [type {router | oob}]
no snmp-server community
community [ ip-address ]
•
community— Community string that acts like a password and permits access to the
SNMP protocol. (Range: 1-20 characters)
•
ro —Indicates read-only access (default).
•
rw —Indicates read-write access.
•
su —Indicates SNMP administrator access.
•
ip-address —Specifies the IP address of the management station. If no IP address is
specified, all management stations are permitted. For information on specifying out-of-
band IP addresses, see the user guidelines.
•
view-name —Specifies the name of a previously defined view. For information on views,
see the user guidelines. (Range: 1-30 characters)
• group-name—Specifies the name of a previously defined group. For information on
groups, see the user guidelines. (Range: 1-30 characters)
Console # show snmp filters
Name OID Tree Type
----------- ----------------------- ---------
user-filter 1.3.6.1.2.1.1 Included
user-filter 1.3.6.1.2.1.1.7 Excluded
user-filter 1.3.6.1.2.1.2.2.1.*.1 Included