Owner's Manual

40 Command Groups
www.dell.com | support.dell.com
Radius Commands
RIP Commands
class Defines the traffic classification and enters the policy-map class
configuration mode.
PM
police Defines a policer for the classified traffic. PM
police aggregate Applies an aggregate policer to multiple classes within the same policy
map.
PM
trust Configures the trust state. PM
set Sets new values in the IP packet. PM
service-policy Applies a policy map to the interface input. IC
Command Group Description Mode
radius-server host Specifies a RADIUS server host. GC
radius-server key Sets the authentication and encryption key for all RADIUS
communications between the router and the RADIUS daemon.
GC
radius-server retransmit Specifies the number of times the software searches the list of
RADIUS server hosts.
GC
radius-server source-ip Specifies the source IP address used for communication with RADIUS
servers.
GC
radius-server timeout Sets the interval for which a router waits for a server host to reply. GC
radius-server deadtime Improves RADIUS response times when servers are unavailable. GC
show radius-servers Displays the RADIUS server settings. UE
Command Group Description Mode
router rip enable Enables the RIP on the device. GC
router rip redistribute ospf Advertises routes learned by OSPF in the RIP process. GC
router rip redistribute static Advertises routes statically learned in the RIP process. GC
rip Creates a Routing Information Protocol (RIP) process on an interface. IC
rip passive-interface Disables the sending of routing updates on an interface. IC
rip auto-send Automatically detects if RIP information is required to be sent on the
interface.
IC
rip version Specifies a RIP version. IC