Owner's Manual

500 802.1x Commands
www.dell.com | support.dell.com
802.1 Advanced Features
dot1x auth-not-req
The dot1x auth-not-req VLAN configuration command enables unauthorized devices access to
that VLAN. To disable access, use the
no form of this command.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Default Configuration
User should be authorized to access the VLAN.
Command Mode
VLAN Configuration mode
User Guidelines
An access port cannot be a member in an unauthenticated VLAN. The native VLAN of a
trunk port cannot be an unauthenticated VLAN. For a general port, the PVID can be the
unauthenticated VLAN (although only tagged packets would be accepted in the
unauthorized state.)
Examples
The following example enables unauthorized users access to the VLAN:
EapolReqIdFramesTx The number of EAP Req/Id frames that have been transmitted by this
Authenticator.
EapolReqFramesTx The number of EAP Request frames (other than Rq/Id frames) that
have been transmitted by this Authenticator.
InvalidEapolFramesRx The number of EAPOL frames that have been received by this
Authenticator in which the frame type is not recognized.
EapLengthErrorFramesRx The number of EAPOL frames that have been received by this
Authenticator in which the Packet Body Length field is invalid.
LastEapolFrameVersion The protocol version number carried in the most recently received
EAPOL frame.
LastEapolFrameSource The source MAC address carried in the most recently received EAPOL
frame.
Console (conf) # interface vlan 3
Console(config-if) # dot1x auth-not-req