Owner's Manual

94 Address Table Commands
www.dell.com | support.dell.com
Default Configuration
Disabled - No port security
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In this example, frame forwarding is enabled without learning, and with traps sent every 100
seconds on port g1.
port security routed secure-address
The port security routed secure-address interface configuration command adds MAC-layer secure
addresses to a routed port. Use the
no form of this command to delete the MAC addresses.
Syntax
port security routed secure-address mac-address
no port security routed secure-address mac-address
• mac-address —Specify a MAC address.
Default Configuration
No addresses are defined.
Command Mode
Interface configuration (Ethernet, port-channel). Cannot be configured for a range of
interfaces (range context).
User Guidelines
The command enables adding secure MAC addresses to a routed ports in port security mode.
The command is available when the port is a routed port and in port security mode. The
address is deleted if the port exits the security mode or is not a routed port.
Console (config)# interface ethernet g1
Console (config-if)# port security forward trap 100