Command Reference Guide

162 Fabric OS Command Reference
53-1002746-01
configure
2
Stage FDISC logins with busy reject:
This parameter, if nonzero, enables staging of FDISC logins by rejecting the
FDISC requests with "logical busy", when the requests are more than the number
of configured "logins per second". It also specifies the number of FDISC requests
that will always be accepted first without reject.
Enforce FLOGI/FDISC login
Setting this flag allows a second F_Port login (FLOGI/FDISC login) in the event of
two devices attempting to log in with the same PWWN. In default mode (zero) the
first FLOGI/FDISC login takes precedence over the second. When the flag is set
to 1, the second LOGI/FDISC login takes precedence over the first. This
parameter applies only to NPIV ports. You must disable the switch to change this
parameter.
Zoning Operation Parameters
The following zoning operation parameter can be modified.
Disable NodeName Zone Checking
Specify 1 to disable using node WWN when specifying nodes in the zone
database. Specify 0 to enable using node WWN when specifying nodes in the
zone data. The default value is 0. This value must be set to 1 for interpretability.
RSCN Transmission Mode
The RSCN transmission modes and values are as follows:
End-device RSCN Transmission Mode
Values are as follows:
0
RSCN only contains single PID
1
RSCN contains multiple PIDs (Default)
2
Fabric addresses RSCN
Domain RSCN to End-device
Values are as follows:
0
Disabled. No domain RSCN is sent to the end-device for the switch IP address or
name change.
1
Enabled. Domain RSCN is sent to the end-device for the switch IP address or
name change.
Arbitrated Loop Parameters
Arbitrated Loop Parameter and their values are as follows:
Send FAN frames?
Specifies that fabric address notification (FAN) frames be sent to public loop
devices to notify them of their node ID and address. When set to 1, frames are
sent; when set to 0, frames are not sent. The default value is 1.
Enable CLOSE on OPEN received?
If this is set, a CLS is returned immediately to an OPN if no buffers are available.
This is required for TachLite. The valid range is 0 to 4. The default value is 0.