Command Reference Guide

Fabric OS Command Reference 327
53-1002746-01
fcrFabricShow
2
fcrFabricShow
Displays the FC Routers on a backbone fabric.
SYNOPSIS fcrfabricshow
fcrfabricshow --name
fcrfabricshow --help
DESCRIPTION Use this command to display information about FC Routers that exist in an FC Router backbone fabric.
The existing syntax is maintained for IPv6 support. When IPv6 addresses are not configured, the output
of fcrFabricShow displays the IPv4 format. Use the --name option to display the fabric name along with
EX-port, FID, and switch name.
The message "No active FC Routers found" is displayed if no active FC Routers are present on the
backbone fabric.
The following information is displayed for each FC Router found on the backbone fabric:
WWN
The world wide name of the FC Router.
Domain ID
The domain ID of the FC Router. This domain ID is relevant only on the backbone
fabric.
Info
The Ethernet IP address and switch name of the FC Router. When IPv6
addresses are configured, only the static IP address displays for each FC Router
found on the backbone fabric.
EX_Ports
A listing of active EX_Ports for the FC Router and information about these
EX_Ports. This information includes:
EX_Port
The port number for the EX_Port. An asterisk (*) at the end of the line indicates
that the EX_Port is a Remote Router Port.
FID
The fabric ID of the EX_Port.
Neighbor Switch Info (WWN, enet IP, name)
The WWN, Ethernet IP address, and switch name of the switch attached to the
EX_Port.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operand.
--name
Displays the FC Routers on a backbone fabric with edge fabric names.
--help
Displays the command usage.