Command Reference Guide

Fabric OS Command Reference 739
53-1002746-01
portDPortTest
2
To terminate the D_Port test on a single port:
switch:admin> portdporttest --stop
To display the runtime status for a single D_Port while the test is in progress:
switch:admin> portdporttest --show 42
D-Port Information:
==============================================
Port: 42
Remote WWNN: 10:00:00:05:1e:e5:e4:00
Remote port: 343
Mode: Manual
No. of test frames: 12 Million
Duration of test (HH:MM):00:01
Test frame size: 1024 Bytes
Payload Pattern: JTSPAT
FEC (enabled/option/active): Yes/No/No
CR (enabled/option/active): No/No/No
Start time: Mon Jan 16 05:57:52 2012
End time: Mon Jan 16 05:58:56 2012
Status: PASSED
===================================================================
Test Start time Result EST(HH:MM:SS) Comments
===================================================================
Electrical loopback 05:57:52 PASSED -------- ----------
Optical loopback 05:58:07 PASSED -------- ----------
Link traffic test 05:58:14 PASSED -------- ----------
====================================================================
Roundtrip link latency: 934 nano-seconds
Estimated cable distance: 1 meters
Buffers required: 1 (for 1024 byte frames at 16Gbps speed)
To display D_Port summary information:
switch:admin> portdporttest --show all 42
Port State SFP Capabilities Test Result
=============================================
24 ONLINE E,O PASSED
26 ONLINE E,O RESPONDER
33 OFFLINE --- RESPONDER
SEE ALSO dataTypeShow, fabricLog, portCfg, portCfgDPort, portShow, switchShow