Installation guide

8 PowerConnect
TM
B-Series TI24X Getting Started Guide
53-1002050-01
Power precautions
DANGER
Disconnect the power cord from all power sources to completely remove power from the device.
DANGER
Make sure to choose the appropriate circuit device depending on the number of AC power supplies
installed in the device. The minimum current draw for the system is one AC power supply.
DANGER
Power supplies are hot swappable. However, Dell recommends that you disconnect the power supply
from AC power before installing or removing the supply. The device can be running while a power supply
is being installed or removed, but the power supply itself should not be connected to a power source.
Otherwise, you could be injured or the power supply or other parts of the device could be damaged.
DANGER
Make sure that the power source circuits are properly grounded, then use the power cord supplied with
the device to connect it to the power source.
DANGER
If the installation requires a different power cord than the one supplied with the device, make sure you
use a power cord displaying the mark of the safety agency that defines the regulations for power cords in
your country. The mark is your assurance that the power cord can be used safely with the device.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 MB ohm resistor.
DANGER
Circuit Overloading - Consideration should be given to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this
concern.