Installation guide

PowerConnect
TM
B-Series TI24X Getting Started Guide 11
53-1002050-01
Connecting AC power
Take the following actions before connecting power:
• Ensure the electrical outlet is near the equipment and easily accessible.
• If the outlet is not rated 115 or 120V, stop and get the appropriate cable for the outlet.
• Ensure that the power supply is fully and properly inserted.
DANGER
If the installation requires a different power cord than the one supplied with the chassis, make sure you
use a power cord displaying the mark of the safety agency that defines the regulations for power cords in
your country. The mark is your assurance that the power cord can be used safely with the chassis.
Connect the AC power as follows:
1. Remove the power cord from the shipping package.
2. Attach the AC power cord to the AC connector on the rear panel as shown in Figure 3.
Align the locating notch on the underside of the AC power cord before inserting.
FIGURE 3 Attaching the AC power cord
3. Insert the power cord plug into a properly grounded 115V or 120V electrical outlet.
4. Repeat steps 1 through 3 for the second power supply, if so configured.
Verifying proper operation
After you complete the hardware installation, to check for proper operation, follow these steps:
1. If power is not yet applied to the device, switch on the power at the power source.
2. Verify that the LED on the power supply and the system power LED are solid green.