Installation guide

4 PowerConnect

B-Series TI24X Getting Started Guide

53-1002050-01

Items required for installation

This section lists items shipped with the PowerConnect

B-Series TI24X device and items you will need for

installation.

Items shipped with units

The following items are shipped:

• Dell PowerConnect

B-Series TI24X device with AC power supply installed

• AC power cord

• Power jumper cord

• Rack mount brackets and mounting screws (already secured on the device)

• Rubber feet for free-standing use

• A straight-through EIA or TIA DB-9 serial cable (F/F) to connect the management station to the device

• Warranty card

• Web pointer card that references software images and user documentation

NOTE

If any items are missing, contact the place of purchase.

Items that you must provide

To install the PowerConnect

B-Series TI24X device on a Telco rack, you must provide the following items:

• Assembled Telco equipment rack

• Four standard #12-24 pan-head screws for mounting the chassis to equipment racks

• #2 Phillips-head screwdriver

If you are installing the device in a non-Telco equipment rack, you must also provide a long mounting bracket kit.

For performing initial setup tasks, such as setting passwords and assigning an IP address, you must also provide a

management station such as a PC running terminal emulation software or a terminal.

Site planning and safety guidelines

The following steps and safety precautions are required to ensure correct installation and operation.

Site planning

Follow these guidelines to ensure your site is ready for installation.

Cabling infrastructure

Ensure that the proper cabling is installed in the site. For information on cabling, see your hardware installation

guide.