Quick Reference Guide

1046 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Syslog messages
34
Alert Management module at state changed from
<module-state> to <module-state>.
Indicates a state change in a management
module.
The <module-state> can be one of the
following:
• active
• standby
• crashed
• coming-up
• unknown
Alert OSPF LSA Overflow, LSA Type =
<lsa-type>
Indicates an LSA database overflow.
The <lsa-type> parameter indicates the
type of LSA that experienced the overflow
condition. The LSA type is one of the
following:
• 1 – Router
• 2 – Network
• 3 – Summary
• 4 – Summary
• 5 – External
Alert OSPF Memory Overflow OSPF has run out of memory.
Alert Power supply <num>, <location>, failed A power supply has failed.
The <num> is the power supply number.
The <location> describes where the failed
power supply is in the chassis.
Alert System: No Free Tcam Entry available.
System will be unstable
The limit for the TCAM routing entries has
been reached. You must reboot the device.
Alert System: Temperature is over shutdown level,
system is going to be reset in <num>
seconds
The chassis temperature has risen above
shutdown level. The system will be shut
down in the amount of time indicated.
Alert Temperature <degrees> C degrees, warning
level <warn-degrees> C degrees, shutdown
level <shutdown-degrees> C degrees
Indicates an over temperature condition on
the active module.
The <degrees> value indicates the
temperature of the module.
The <warn-degrees> value is the warning
threshold temperature configured for the
module.
The <shutdown-degrees> value is the
shutdown temperature configured for the
module.
Critical Authentication shut down <portnum> due to
DOS attack
Denial of Service (DoS) attack protection
was enabled for multi-device port
authentication on the specified <portnum>,
and the per-second rate of RADIUS
authentication attempts for the port
exceeded the configured limit. The device
considers this to be a DoS attack and
disables the port.
Debug BGP4: Not enough memory available to run
BGP4
The device could not start the BGP4 routing
protocol because there is not enough
memory available.
TABLE 168 Dell Syslog messages (Continued)
Message level Message Explanation