Quick Reference Guide

1054 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Syslog messages
34
Notification ACL port fragment packet inspect rate
<rate> exceeded on port <portnum>
The fragment rate allowed on an individual
interface has been exceeded.
The <rate> indicates the maximum rate
allowed.
The <portnum> indicates the port.
This message can occur if fragment
thottling is enabled.
Notification ACL system fragment packet inspect rate
<rate> exceeded
The fragment rate allowed on the device
has been exceeded.
The <rate> indicates the maximum rate
allowed.
This message can occur if fragment
thottling is enabled.
Notification Authentication Disabled on <portnum> The multi-device port authentication feature
was disabled on the on the specified
<portnum>.
Notification Authentication Enabled on <portnum> The multi-device port authentication feature
was enabled on the on the specified
<portnum>.
Notification BGP Peer <ip-addr> DOWN (IDLE) Indicates that a BGP4 neighbor has gone
down.
The <ip-addr> is the IP address of the
neighbor BGP4 interface with the device.
Notification BGP Peer <ip-addr> UP (ESTABLISHED) Indicates that a BGP4 neighbor has come
up.
The <ip-addr> is the IP address of the
neighbor BGP4 interface with the
PowerConnect device.
Notification DOT1X issues software but not physical port
down indication of Port <portnum> to other
software applications
The device has indicated that the specified
is no longer authorized, but the actual port
may still be active.
Notification DOT1X issues software but not physical port
up indication of Port <portnum> to other
software applications
The device has indicated that the specified
port has been authenticated, but the actual
port may not be active.
Notification DOT1X: Port <port_id> Mac <mac_address>
-user <user_id> - RADIUS timeout for
authentication
The RADIUS session has timed out for this
802.1x port.
Notification ISIS ENTERED INTO OVERLOAD STATE The Layer 3 Switch has set the overload bit
to on (1), indicating that the Layer 3 Switch
IS-IS resources are overloaded.
Notification ISIS EXITING FROM OVERLOAD STATE The Layer 3 Switch has set the overload bit
to off (0), indicating that the Layer 3 Switch
IS-IS resources are no longer overloaded.
Notification ISIS L1 ADJACENCY DOWN <system-id> on
circuit <circuit-id>
The Layer 3 Switch adjacency with this
Level-1 IS has gone down.
The <system-id> is the system ID of the IS.
The <circuit-id> is the ID of the circuit over
which the adjacency was established.
TABLE 168 Dell Syslog messages (Continued)
Message level Message Explanation