Quick Reference Guide

76 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
IPv6 management (IPv6 host support)
5
I Indicates that the user interrupted ping.
Configuring an IPv6 Syslog server
To enable IPv6 logging, specify an IPv6 Syslog server. Enter a command such as the following.
PowerConnect(config)# log host ipv6 2000:2383:e0bb::4/128
Syntax: log host ipv6 ipv6-address [ udp-port-num ]
• The ipv6-address must be in hexadecimal using 16-bit values between colons as documented
in RFC 2373.
• The udp-port-num optional parameter specifies the UDP application port used for the Syslog
facility.
Viewing IPv6 SNMP server addresses
Some of the show commands display IPv6 addresses for IPv6 SNMP servers. The following shows
an example output for the show snmp server command.
PowerConnect# show snmp server
Contact:
Location:
Community(ro): .....
Traps
Warm/Cold start: Enable
Link up: Enable
Link down: Enable
Authentication: Enable
Locked address violation: Enable
Power supply failure: Enable
Fan failure: Enable
Temperature warning: Enable
STP new root: Enable
STP topology change: Enable
vsrp: Enable
Total Trap-Receiver Entries: 4
Trap-Receiver IP-Address Port-Number Community
1 192.147.201.100 162 .....
2 4000::200 162 .....
3 192.147.202.100 162 .....
4 3000::200 162 .....