Quick Reference Guide
PowerConnect B-Series TI24X Configuration Guide 1069
53-1002269-02
Appendix
A
Network Monitoring
This appendix describes the remote monitoring features available on devices.
Basic management
The following sections contain procedures for basic system management tasks.
Viewing system information
You can access software and hardware specifics for a Layer 2 Switch or Layer 3 Switch. For
software specifics, refer to “Determining the software versions installed and running on a device”
on page 39.
To view the software and hardware details for the system, enter the show version command. The
following shows an example output.
Syntax: show version
Viewing configuration information
You can view a variety of configuration details and statistics with the show option. The show option
provides a convenient way to check configuration changes before saving them to flash.
The show options available will vary for Layer 2 Switches and Layer 3 Switches and by configuration
level.
To determine the available show commands for the system or a specific level of the CLI, enter the
following command.
PowerConnect#show ?
PowerConnect# show version
SW: Version 4.2.00b Copyright (c) 1996-2010 Brocade Communications Systems, Inc.
Compiled on Dec 02 2010 at 08:07:06 labeled as TIR07202b071
(6092645 bytes) from Secondary TIR07202b071
Compressed Boot-Monitor Image size = 373767, Version:04.1.00T205 (grz04100)
HW: Stackable TurboIron-X24
==========================================================================
Serial #: BFF2342E00X
P-ASIC 0: type B820, rev 01 subrev 00
==========================================================================
833 MHz Power PC processor 8541 (version 32/0020) 66 MHz bus
512 KB boot flash memory
31744 KB code flash memory
512 MB DRAM
The system uptime is 5 minutes 34 seconds
The system : started=warm start reloaded=by "reload"