Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
1101110211031104110511061107110811091110
1074 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Basic management
A
Example
To configure traffic counters for outbound traffic in a specific port region, enter a command such as
the following.
PowerConnect(config)#transmit-counter 1 port 1 region vlan all prio all enable
The above command creates and enables traffic counter 1 on all ports that are in the same port
region as port 1. The device will count the number of packets transmitted in this port region that
belong to any VLAN and have any assigned priority queue.
Syntax: [no] transmit-counter <counter-ID> port <port-num> only | region vlan <vlan-ID> | all
priority <priority-queue> | all enable
Enter the no form of the command to remove the outbound traffic counter.
The <counter-ID> parameter identifies the traffic counter. You can configure up to 64 traffic
counters. Enter a number from 1 – 64.
The <port-num> parameter is the port number to which enhanced traffic counters will apply. Enter
the port number followed by only to apply the enhanced traffic counter to a specific port, or enter
the port number followed by region to apply the enhanced traffic counter to all of the ports in the
port region.
The <vlan-ID> parameter identifies the VLAN ID for which outbound traffic will be counted. Enter a
number from 0 – 4095 or enter all to indicate all VLANs.
The <priority-queue> parameter identifies the 802.1p priority queue for which traffic will be
counted. Enter a number from 0 – 7 or enter all to indicate all priority queues.
Displaying enhanced traffic counter profiles
To display the details of the traffic counters configured on your device, enter the show
transmit-counter profiles command. The following shows an example output.
Displaying enhanced traffic counter statistics
To display the traffic counters for outbound traffic, enter the show transmit-counter profiles
command.
NOTE
Once the enhanced traffic counters are displayed, the counters are cleared (reset to zero).
The following shows an example output.