Quick Reference Guide

106 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Configuring STP related features
6
The STP information is shown in bold type in this example.
Syntax: show interfaces [ethernet <portnum>] | [loopback <num>] | [ve <num>] | [brief]
You also can display the STP states of all ports by entering a command such as the following, which
uses the brief parameter.
In the example above, only one port, 11, is forwarding traffic toward the root bridge.
Configuring STP related features
STP features extend the operation of standard STP, enabling you to fine tune standard STP and
avoid some of its limitations.
This section describes how to configure these parameters on Layer 3 Switches using the CLI.