Quick Reference Guide

PowerConnect B-Series TI24X Configuration Guide 249
53-1002269-02
UDLD overview
9
Syntax: show link-keepalive [ethernet<portnum>]
The show interface ethernet command also displays the UDLD state for an individual port. In
addition, the line protocol state listed in the first line will say “down” if UDLD has brought the port
down. An example is given below.
In this example, the port has been brought down by UDLD. Notice that in addition to the
information in the first line, the port state on the fourth line of the display is listed as DISABLED.
Clearing UDLD statistics
To clear UDLD statistics, enter the following command.
PowerConnect#clear link-keepalive statistics
TABLE 39 CLI display of detailed UDLD information
This field... Displays...
Current State The state of the logical link. This is the link between this port and the port on the other end
of the link.
Remote MAC Addr The MAC address of the port or device at the remote end of the logical link.
Local Port The port number on this device.
Remote Port The port number on the device at the remote end of the link.
Local System ID A unique value that identifies this device. The ID can be used by Dell technical support for
troubleshooting.
Remote System ID A unique value that identifies the device at the remote end of the link.
Packets sent The number of UDLD health-check packets sent on this port.
Packets received The number of UDLD health-check packets received on this port.
Transitions The number of times the logical link state has changed between up and down.
Port blocking Information used by Dell technical support for troubleshooting.
Link-vlan The ID of the tagged VLAN in the UDLD packet.
BM disabled Information used by Dell technical support for troubleshooting.
PowerConnect#show interface ethernet 1
FastEthernet1 is down, line protocol is down, link keepalive is enabled
Hardware is FastEthernet, address is 00e0.52a9.bbca (bia 00e0.52a9.bbca)
Configured speed auto, actual unknown, configured duplex fdx, actual unknown
Member of L2 VLAN ID 1, port is untagged, port state is DISABLED
STP configured to ON, priority is level0, flow control enabled
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 0 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants, DMA received 0 packets
19 packets output, 1216 bytes, 0 underruns
Transmitted 0 broadcasts, 19 multicasts, 0 unicasts
0 output errors, 0 collisions, DMA transmitted 19 packets