Quick Reference Guide

PowerConnect B-Series TI24X Configuration Guide 295
53-1002269-02
Configuring super aggregated VLANs
10
PowerConnectB(config)# vlan 105 by port
PowerConnectB(config-vlan-105)# tagged ethernet 6
PowerConnectB(config-vlan-105)# untagged ethernet 5
PowerConnectB(config-vlan-105)# exit
PowerConnectB(config)# write memory
Commands for device C
Since device C is aggregating channel VLANs from devices A and B into a single path, you need to
change the tag type and enable VLAN aggregation.
PowerConnectC(config)# tag-type 9100
PowerConnectC(config)# aggregated-vlan
PowerConnectC(config)# vlan 101 by port
PowerConnectC(config-vlan-101)# tagged ethernet 7
PowerConnectC(config-vlan-101)# untagged ethernet 8
PowerConnectC(config-vlan-101)# exit
PowerConnectC(config)# vlan 102 by port
PowerConnectC(config-vlan-102)# tagged ethernet 7
PowerConnectC(config-vlan-102)# untagged ethernet 9
PowerConnectC(config-vlan-102)# exit
PowerConnectC(config)# write memory
Commands for device D
Device D is at the other end of path and separates the channels back into individual VLANs. The
tag type must be the same as tag type configured on the other core device (Device C). In addition,
VLAN aggregation also must be enabled.
PowerConnectD(config)# tag-type 9100
PowerConnectD(config)# aggregated-vlan
PowerConnectD(config)# vlan 101 by port
PowerConnectD(config-vlan-101)# tagged ethernet 7
PowerConnectD(config-vlan-101)# untagged ethernet 8
PowerConnectD(config-vlan-101)# exit
PowerConnectD(config)# vlan 102 by port
PowerConnectD(config-vlan-102)# tagged ethernet 7
PowerConnectD(config-vlan-102)# untagged ethernet 9
PowerConnectD(config-vlan-102)# exit
PowerConnectD(config)# write memory
Commands for device E
Since the configuration in Figure 68 on page 291 is symmetrical, the commands for configuring
device E are identical to the commands for configuring device A.
PowerConnectE(config)# vlan 101 by port
PowerConnectE(config-vlan-101)# tagged ethernet 6
PowerConnectE(config-vlan-101)# untagged ethernet 1
PowerConnectE(config-vlan-101)# exit
PowerConnectE(config)# vlan 102 by port
PowerConnectE(config-vlan-102)# tagged ethernet 6
PowerConnectE(config-vlan-102)# untagged ethernet 2
PowerConnectE(config-vlan-102)# exit
PowerConnectE(config)# vlan 103 by port
PowerConnectE(config-vlan-103)# tagged ethernet 6
PowerConnectE(config-vlan-103)# untagged ethernet 3
PowerConnectE(config-vlan-103)# exit