Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
361362363364365366367368369370
336 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Displaying and determining the status of aggregate links
11
• LACP brings the port back up
• The port joins a trunk group
Displaying link aggregation and port status information
Use the show link-aggregation command to determine the operational status of ports associated
with aggregate links.
To display the link aggregation information for a specific port, enter a command such as the
following at any level of the CLI.
PowerConnect# show link-aggregation ethernet 5
System ID: 00e0.52a9.bb00
Port [Sys P] [Port P] [ Key ] [Act][Tio][Agg][Syn][Col][Dis][Def][Exp][Ope]
5 1 1 20000 No L Agg Syn Col Dis No No Ope
The command in this example shows the link aggregation information for port 1.
To display the link aggregation information for all ports on which link aggregation is enabled, enter
the following command at any level of the CLI.
Syntax: show link-aggregation [ethernet <portnum>]
Use ethernet <portnum> to display link-aggregation information for a specific port.
NOTE
Ports that are configured as part of an aggregate link must also have the same key. For more
information about assigning keys, refer to the section “Link aggregation parameters” on page 330.
The show link aggregation command output is described in “CLI display of link aggregation
information” on page 336.
TABLE 47 CLI display of link aggregation information
This field... Displays...
System ID Lists the base MAC address of the device. This is also the MAC address of port 1 .
Port Lists the port number.
Sys P Lists the system priority configured for this port.
Port P Lists the port link aggregation priority.
Key Lists the link aggregation key.