Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
371372373374375376377378379380
PowerConnect B-Series TI24X Configuration Guide 339
53-1002269-02
Configuring single link LACP
11
Configuration notes
• This feature is supported on 1-GbE and 10-GbE ports.
• This feature is not supported on static trunk ports.
• This feature is not intended for the creation of trunk groups.
• The single link LACP timer is always short (3 seconds) and is not configurable. PDUs are sent
out every three seconds.
• This feature is not supported on ports that have the link-keepalive command (UDLD)
configured.
CLI syntax
To form a single link LACP, the port on both sides of the link must have LACP enabled. You can then
define a single link LACP at the interface level of the device by entering the following command.
PowerConnect(config)#interface ethernet 1
PowerConnect(config-if-e10000-1)#link-aggregate configure singleton
Link-aggregation active
Syntax: [no] link-aggregate configure singleton
When single link LACP is configured, the show link-aggregate command displays the following
information.
If singleton is configured on the port, the “Key” column displays “singleton”. Refer to “CLI display of
link aggregation information” on page 336 to interpret the information on the displayed output.
Also, when ports are logically brought up or down while singleton is configured on the port, the
following Syslog messages are generated:
• Logical link on interface ethernet <port#> is up.
• Logical link on interface ethernet <port#> is down.