Quick Reference Guide

350 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Displaying GVRP information
12
• CPU utilization statistics
• GVRP diagnostic information
Displaying GVRP configuration information
To display GVRP configuration information, enter a command such as the following.
Syntax: show gvrp [ethernet <port-num>]
This display shows the following information.
TABLE 49 CLI display of summary GVRP information
This field... Displays...
Protocol state The state of GVRP. The display shows one of the following:
• GVRP is disabled on the system
• GVRP is enabled on the system
GVRP BASE VLAN ID The ID of the base VLAN used by GVRP.
GVRP MAX Leaveall Timer The maximum number of ms to which you can set the Leaveall timer.
NOTE: To change the maximum value, refer to “Increasing the maximum
configurable value of the Leaveall timer” on page 346.
GVRP Join Timer The value of the Join timer.
NOTE: For descriptions of the Join, Leave, and Leaveall timers or to change the
timers, refer to “Changing the GVRP timers” on page 347.
GVRP Leave Timer The value of the Leave timer.
PowerConnect# show gvrp
GVRP is enabled on the system
GVRP BASE VLAN ID : 4093
GVRP MAX Leaveall Timer : 300000 ms
GVRP Join Timer : 200 ms
GVRP Leave Timer : 600 ms
GVRP Leave-all Timer : 10000 ms
===========================================================================
Configuration that is being used:
block-learning ethe 3
block-applicant ethe 7 ethe 11
enable ethe 1 to 7 ethe 1 ethe 7 ethe 11
===========================================================================
Spanning Tree: SINGLE SPANNING TREE
Dropped Packets Count: 0
===========================================================================
Number of VLANs in the GVRP Database: 15
Maximum Number of VLANs that can be present: 4095
===========================================================================