Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
461462463464465466467468469470
436 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
ACL and rate limit counting
17
Viewing ACL and rate limit counters
When ACL counting is enabled on the device, you can use show commands to display the total
packet count and byte count of the traffic filtered by ACL statements. The output of the show
commands also display the rate limiting traffic counters, which are automatically enabled for active
rate limiting traffic policies.
Use either the show access-list accounting command or the show statistics traffic-policy command
to display ACL and traffic policy counters. The output of these commands are identical. The
following shows an example output.
Syntax: show access-list accounting traffic-policy [<TPD name>]
or
Syntax: show statistics traffic-policy [<TPD name>]
Table 71 explains the output of the show access-list accounting and show statistics traffic-policy
commands.
TABLE 71 ACL and rate limit counting statistics
This line... Displays...
Traffic Policy The name of the traffic policy.
General Counters
Port Region # The port region to which the active traffic policy applies.
Byte Count The number of bytes that were filtered (matched ACL clauses).
Packet Count The number of packets that were filtered (matched ACL clauses).
Rate Limiting Counters
Port Region# The port region to which the active traffic policy applies.
Green Conformance The number of bytes that did not exceed the CIR packet rate.
Yellow Conformance The number of bytes that exceeded the CIR packet rate.
Red Conformance The number of bytes that exceeded the PIR packet rate.