Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
491492493494495496497498499500
PowerConnect B-Series TI24X Configuration Guide 461
53-1002269-02
PIM SM snooping show commands
18
Syntax: show ip pimsm-snooping vlan <vlan-id>
Enter the ID of the VLAN for the vlan <vlan-id> parameter.
If you want to display PIM SM snooping information for one source or one group, enter a command
as in the following example. The command also displays the (source, port) list of the group.
Syntax: show ip pimsm-snooping <group-address> | <source-address>
If the address you entered is within the range of source addresses, then the router treats it as the
source address. Likewise, if the address falls in the range of group addresses, then the router
assumes that you are requesting a report for that group.
This display shows the following information.
Displaying PIM SM snooping information for a specific
group or source group pair
To display PIM SM snooping information for a specific group, enter a command such as the
following at any level of the CLI.
Table 0.8:
This field... Displays...
VLAN ID The port-based VLAN to which the information listed below apply and the number of
members in the VLAN.
PIM SM Neighbor list The PIM SM routers that are attached to the Layer 2 Switch ports.
The value following “expires” indicates how many seconds the Layer 2 Switch will wait for a
hello message from the neighbor before determining that the neighbor is no longer present
and removing the neighbor from the list.
Multicast Group The IP address of the multicast group.
NOTE: The fid and camindex values are used by Dell Technical Support for
troubleshooting.
Forwarding Port The ports attached to the group receivers. A port is listed here when it receives a join
message for the group, an IGMP membership report for the group, or both.
PIMv2 Group Port The ports on which the Layer 2 Switch has received PIM SM join messages for the group.
Source, Port list The IP address of each PIM SM source and the Layer 2 Switch ports connected to the
receivers of the source.