Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
491492493494495496497498499500
462 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Clear commands for IGMP snooping
18
To display PIM SM snooping information for a specific (source, group) pair, enter a command such
as the following at any level of the CLI.
Syntax: show ip multicast pimsm-snooping <group-address> [<source-ip-address>]
The device determines which address is the group address and which one is the source address
based on the ranges that the address fall into. If the address is within the range of source
addresses, then the router treats it as the source address. Likewise, if the address falls in the
range of group addresses, then the router assumes it is a group address.
The output shows the following information.
Clear commands for IGMP snooping
The clear IGMP snooping commands should be used only in troubleshooting conditions, or to
recover from errors.
Clearing the IGMP mcache
To clear the mcache on all VLANs, enter the following command.
PowerConnect# clear ip multicast mcache
Syntax: clear ip multicast mcache
Clearing the mcache on a specific VLAN
To clear the mcache on a specific VLAN, enter the following command.
PowerConnect# clear ip multicast vlan 10 mcache
Syntax: clear ip multicast vlan <vlan-id> mcache
Table 0.9:
This field... Displays...
vlan The VLAN membership ID of the source.
port The port on which the source is sending traffic. In this example, the port number is 1.
age The age of the port, in seconds.
src The source address and age. The age (number of seconds) is indicated in brackets
immediately following the source.