Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
521522523524525526527528529530
496 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
PIM Sparse
19
Displaying the RP set list
To display the RP set list, enter the following command at any CLI level.
Syntax: show ip pim rp-set
This display shows the following information.
Displaying multicast neighbor information
To display information about the Layer 3 Switch PIM neighbors, enter the following command at any
CLI level.
TABLE 81 Output of show ip pim rp-hash
This field... Displays...
RP Indicates the IP address of the Rendezvous Point (RP) for the specified PIM Sparse group.
Following the IP address is the port or virtual interface through which this Layer 3 Switch learned
the identity of the RP.
Info source Indicates the IP address on which the RP information was received.
Following the IP address is the method through which this Layer 3 Switch learned the identity of
the RP.
TABLE 82 Output of show ip pim rp-set
This field... Displays...
Number of group prefixes The number f PIM Sparse group prefixes for which the RP is responsible.
Group prefix Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
RPs expected/received Indicates how many RPs were expected and received in the latest Bootstrap
message.
RP <num> Indicates the RP number. If there are multiple RPs in the PIM Sparse domain, a
line of information for each of them is listed, and they are numbered in ascending
numerical order.
priority The RP priority of the candidate RP. During the election process, the candidate RP
with the highest priority is elected as the RP.
age The age (in seconds) of this RP-set.
NOTE: If this Layer 3 Switch is not a BSR, this field contains zero. Only the BSR
ages the RP-set.