Quick Reference Guide

498 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
PIM Sparse
19
Syntax: show ip pim flowcache
This display shows the following information.
Displaying the PIM multicast cache
To display the PIM multicast cache, enter the following command at any CLI level.
PowerConnect
(* 228.1.0.88) RP 1.1.1.1, in e21 (e21), cnt=0
Source is directly connected
Sparse Mode, RPT=1 SPT=0 REG=0 MSDP Adv=0 MSDP Create=0
L3 (SW) 3: e2(VL33), e1(VL5), TR(e13,e14)(VL55)
fast=1 slow=0 pru=1 graft
age=0s up-time=4123m HW=0
Syntax:
This display shows the following information.
PowerConnect# show ip pim flowcache 238.0.0.1
Multicast flow (24.1.1.100 238.0.0.1):
Vidx for source vlan forwarding: 2080
[mcastPrintMll]: vrId 0, ipGrp 238.0.0.1, grpPrefix 32, ipSrc 24.1.1.100, srcPre
32, nextHopIdx 0
1 flow printed
TABLE 84 Output of show ip pim flowcache
This field... Displays...
Source Indicates the source of the PIM Sparse group.
Group Indicates the PIM Sparse group.
Parent Indicates the port or virtual interface from which the Layer 3 Switch receives packets from the
group source.
CamFlags This field is used by Dell technical support for troubleshooting.
CamIndex This field is used by Dell technical support for troubleshooting.
Fid This field is used by Dell technical support for troubleshooting.
Flags This field is used by Dell technical support for troubleshooting.
TABLE 85 Output of show ip pim mcache
This field... Displays...
(<source>, <group>) The comma-separated values in parentheses is a source-group pair.
The <source> is the PIM source for the multicast <group>. For example, the following entry
means source 209.157.24.162 for group 239.255.162.1:
(209.157.24.162,239.255.162.1)
If the <source> value is * (asterisk), this cache entry uses the RP path. The * value means
“all sources”.
If the <source> is a specific source address, this cache entry uses the SPT path.
RP<ip-addr> Indicates the RP for the group for this cache entry.
NOTE: The RP address appears only if the RPT flag is set to 1 and the SPT flag is set to 0
(see below).