Quick Reference Guide

500 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
PIM Sparse
19
Syntax: show ip pim traffic
NOTE
If you have configured interfaces for standard PIM (dense mode) on the Layer 3 Switch, statistics for
these interfaces are listed first by the display.
This display shows the following information.
Displaying and clearing PIM errors
If you want to determine how many PIM errors there are on the device, enter the following
command.
PowerConnect# show ip pim error
**** Warning counter pim route change = 1
HW tagged replication enabled, SW processed pkts 0
Syntax: show ip pim error
TABLE 86 Output of show ip pim traffic
This field... Displays...
Port The port or virtual interface on which the PIM interface is configured.
Hello The number of PIM Hello messages sent or received on the interface.
J/P The number of Join/Prune messages sent or received on the interface.
NOTE: Unlike PIM dense, PIM Sparse uses the same messages for Joins and Prunes.
Register The number of Register messages sent or received on the interface.
RegStop The number of Register Stop messages sent or received on the interface.
Assert The number of Assert messages sent or received on the interface.
Total Recv/Xmit The total number of IGMP messages sent and received by the Layer 3 Switch.
Total Discard/chksum The total number of IGMP messages discarded, including a separate counter for those
that failed the checksum comparison.
PowerConnect# show ip pim traffic
Port Hello J/P Register RegStop Assert
[Rx Tx] [Rx Tx] [Rx Tx] [Rx Tx] [Rx Tx]
e8 19 19 32 0 0 0 37 0 0 0
Port Hello J/P Register RegStop Assert
[Rx Tx] [Rx Tx] [Rx Tx] [Rx Tx] [Rx Tx]
v1 18 19 0 20 0 0 0 0 0 0
Port Hello J/P Register RegStop Assert
[Rx Tx] [Rx Tx] [Rx Tx] [Rx Tx] [Rx Tx]
v2 0 19 0 0 0 16 0 0 0 0
Total 37 57 32 0 0 0 0 0 0 0
IGMP Statistics:
Total Recv/Xmit 85/110
Total Discard/chksum 0/0