Quick Reference Guide

514 PowerConnect B-Series TI24X Configuration Guide

53-1002269-02

Multicast Source Discovery Protocol (MSDP)

PowerConnect(config-router-bsr)# neighbor 32.32.32.2 next-hop-self

PowerConnect(config-router-bsr)# neighbor 34.34.34.4 remote-as 444

PowerConnect(config-router-bsr)# neighbor 34.34.34.4 next-hop-self

PowerConnect(config-router-bsr)# neighbor 31.31.31.1 remote-as 111

PowerConnect(config-router-bsr)# neighbor 31.31.31.1 next-hop-self

PowerConnect(config-router-bsr)# redistribute connected

PowerConnect(config-router-bsr)# write memory

Configuration for Device D

The following set of commands configure the MSDP peers of Device D (1.1.4.1) that are inside and

outside MSDP mesh group 1234. Device D peers inside the mesh group 1234 are 1.1.1.1, 1.1.2.1,

and 1.1.3.1. Device 48.48.48.8 and 134.134.134.13 are also peers of Device D, but are outside

mesh group 1234. Multicast is enabled on Device D interfaces. PIM and BGP are also enabled.

This configuration is not applicable to PowerConnect device because BGP is not supported on the

device.

PowerConnect(config)# router pim

PowerConnect(config)# router msdp

PowerConnect(config-msdp-router)# msdp-peer 1.1.3.1 connect-source loopback 1

PowerConnect(config-msdp-router)# msdp-peer 1.1.1.1 connect-source loopback 1

PowerConnect(config-msdp-router)# msdp-peer 1.1.2.1 connect-source loopback 1

PowerConnect(config-msdp-router)# msdp-peer 48.48.48.8

PowerConnect(config-msdp-router)# msdp-peer 134.134.134.13

PowerConnect(config-msdp-router)# mesh-group 1234 1.1.1.1

PowerConnect(config-msdp-router)# mesh-group 1234 1.1.3.1

PowerConnect(config-msdp-router)# mesh-group 1234 1.1.2.1

PowerConnect(config-msdp-router)# exit

PowerConnect(config)# interface loopback 1

PowerConnect(config-lbif-)# ip address 1.1.4.1 255.255.255.0

PowerConnect(config-lbif-)# ip pim-sparse

PowerConnect(config-lbif-)# exit

PowerConnect(config)# interface ethernet 1/1

PowerConnect(config-if-)# ip address 24.24.24.4 255.255.255.0