Quick Reference Guide
PowerConnect B-Series TI24X Configuration Guide 533
53-1002269-02
IGMP V3
19
Displaying the IGMP status of an interface
You can display the status of a multicast enabled port by entering a command such as the
following.
NOTE
This report is available on Layer 3 Switches.
Syntax: show ip igmp interface [ ve | ethernet <number> <group-address>]
Static A “yes” entry in this column indicates that the multicast group was configured as a
static group; “No” means it was not. Static multicast groups can be configured in IGMP
V2 using the ip igmp static command. In IGMP V3, static sources cannot be configured
in static groups.
Querier “Yes” means that the port is a querier port; “No” means it is not. A port becomes a
non-querier port when it receives a query from a source with a lower source IP address
than the port.
Life Shows the number of seconds the interface can remain in exclude mode. An exclude
mode changes to include mode if it does not receive an "IS_EX" or "TO_EX" message
during a certain period of time. The default is 140 seconds. There is no "life" displayed
in include mode.
Mode Indicates current mode of the interface: Include or Exclude. If the interface is in
Include mode, it admits traffic only from the source list. If an interface is in Exclude
mode, it denies traffic from the source list and accepts the rest.
#_src Identifies the source list that will be included or excluded on the interface.
If IGMP V2 group is in Exclude mode with a #_src of 0, the group excludes traffic from
0 (zero) source list, which means that all traffic sources are included.
Group: If you requested a detailed report, the following information is displayed:
• The multicast group address
• The mode of the group
• A list of sources from which traffic will be admitted (include) or denied (exclude)
on the interface is listed.
• The life of each source list.
If you requested a tracking report, the clients from which reports were received are
identified.
TABLE 90 Output of show ip igmp group (Continued)
This field Displays
PowerConnect#show ip igmp interface
query interval = 60, max response time= 3, group membership time=140
v5: default V2, PIM dense, addr=1.1.1.2
e412 has 0 groups, non-Querier (age=40), default V2
v20: configured V3, PIM dense (port down), addr=1.1.20.1
v110: configured V3, PIM dense, addr=110.110.110.1
e6 has 2 groups, Querier, default V3
group: 239.0.0.1, exclude, life=100, deny 13
group: 224.1.10.1, include, permit 2
e5 has 3 groups, Querier, default V3
group: 224.2.2.2, include, permit 100
group: 239.0.0.1, include, permit 10
group: 224.1.10.1, include, permit 1
Router
Router
Router
Router A
Router B
Router
Group
Member
Group
Member
Group
Member
Group
Member
Group
Member
Group
Member
Multicast Capable Router
Non-Multicast
Capable Routers
Multicast Capable Router
...
...
192.58.4.1
192.3.45.6
IP Tunnel IP Tunnel