Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
581582583584585586587588589590
554 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Configuring LLDP
20
PowerConnect(config)#no lldp advertise link-aggregation ports e 12
Syntax: [no] lldp advertise link-aggregation ports ethernet <port-list> | all
The link aggregation advertisement will appear similar to the following on the remote device, and in
the CLI display output on the device (show lldp local-info).
Link aggregation: not capable
MAC/PHY configuration status
The MAC/PHY configuration and status TLV includes the following information:
• Auto-negotiation capability and status
• Speed and duplex mode
• Flow control capabilities for auto-negotiation
• Port speed down-shift and maximum port speed advertisement
• If applicable, indicates if the above settings are the result of auto-negotiation during link
initiation or of a manual set override action
The advertisement reflects the effects of the following CLI commands:
• speed-duplex
• flow-control
• gig-default
• link-config
By default, the MAC/PHY configuration and status information are automatically advertised when
LLDP is enabled on a global basis. To disable this advertisement, enter a command such as the
following.
PowerConnect(config)#no lldp advertise mac-phy-config-status ports e 4 to 12
The MAC/PHY configuration advertisement will appear similar to the following on the remote
device, and in the CLI display output on the device (show lldp local-info).
Syntax: [no] lldp advertise mac-phy-config-status ports ethernet <port-list> | all
Maximum frame size
The maximum frame size TLV provides the maximum 802.3 frame size capability of the port. This
value is expressed in octets and includes the four-octet Frame Check Sequence (FCS). The default
maximum frame size is 1522. The advertised value may change depending on whether the
aggregated-vlan or jumbo CLI commands are in effect.
By default, the maximum frame size is automatically advertised when LLDP is enabled on a global
basis. To disable this advertisement, enter a command such as the following.
PowerConnect(config)#no lldp advertise max-frame-size ports e 4 to 12
The maximum frame size advertisement will appear similar to the following on the remote device,
and in the CLI display output on the device (show lldp local-info).