Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
661662663664665666667668669670
PowerConnect B-Series TI24X Configuration Guide 633
53-1002269-02
Displaying IP configuration information and statistics
21
Here is an example of how to use the static option. To display only the static IP routes,enter the
following command.
Notice that the route displayed in this example has “S” in the Type field, indicating the route is
static.
Here is an example of how to use the longer option. To display only the routes for a specified IP
address and mask, enter a command such as the following.
This example shows all the routes for networks beginning with 209.159. The mask value and
longer parameter specify the range of network addresses to be displayed. In this example, all
routes within the range 209.159.0.0 – 209.159.255.255 are listed.
The summary option displays a summary of the information in the IP route table. The following is
an example of the output from this command.
Example
Syntax: show ip route summary
In this example, the IP route table contains 35 entries. Of these entries, 6 are directly connected
devices, 28 are static routes, and 1 route was calculated through OSPF. One of the routes has a
zero-bit mask (this is the default route), 27 have a 22-bit mask, 5 have a 24-bit mask, and 1 has a
32-bit mask.
The following table lists the information displayed by the show ip route command.
PowerConnect# show ip route static
Start index: 1 B:BGP D:Connected R:RIP S:Static O:OSPF *:Candidate default
Destination NetMask Gateway Port Cost Type
192.144.33.11 255.255.255.0 209.157.22.12 1 2 S