Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-TI24x
731732733734735736737738739740
704 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Displaying OSPF information
23
Displaying OSPF route information
To display OSPF route information for the router, enter the following command at any CLI level.
Syntax: show ip ospf routes [<ip-addr>]
The <ip-addr> parameter specifies a destination IP address. If you use this parameter, only the
route entries for that destination are shown.
This display shows the following information.
Events OSPF Interface Event:
• Interface_Up = 0x00
• Wait_Timer = 0x01
• Backup_Seen = 0x02
• Neighbor_Change = 0x03
• Loop_Indication = 0x04
• Unloop_Indication = 0x05
• Interface_Down = 0x06
• Interface_Passive = 0x07
Adjacent Neighbor Count The number of adjacent neighbor routers.
Neighbor: The neighbor router ID.
TABLE 117 CLI Display of OSPF route information
This field... Displays...
Index The row number of the entry in the router OSPF route table.
Destination The IP address of the route's destination.
Mask The network mask for the route.
Path_Cost The cost of this route path. (A route can have multiple paths. Each path represents a
different exit port for the Layer 3 Switch.)
Type2_Cost The type 2 cost of this path.
TABLE 116 Output of the show ip ospf interface command (Continued)
This field Displays