Quick Reference Guide

PowerConnect B-Series TI24X Configuration Guide 51
53-1002269-02
Diagnostic error codes and remedies for TFTP transfers
3
Reloading after a specific amount of time
To schedule a system reload to occur after a specific amount of time has passed on the system
clock, use reload after command. For example, to schedule a system reload from the secondary
flash one day and 12 hours later, enter the following command at the global CONFIG level of the
CLI.
PowerConnect# reload after 01:12:00 secondary
Syntax: reload after dd:hh:mm [primary | secondary]
• dd:hh:mm is the number of days, hours, and minutes.
• primary | secondary specifies whether the reload is to occur from the primary code flash
module or the secondary code flash module.
Displaying the amount of time remaining
before a scheduled reload
To display how much time is remaining before a scheduled system reload, enter the following
command from any level of the CLI.
PowerConnect# show reload
Canceling a scheduled reload
To cancel a scheduled system reload using the CLI, enter the following command at the global
CONFIG level of the CLI.
PowerConnect# reload cancel
Diagnostic error codes and remedies for TFTP transfers
If an error occurs with a TFTP transfer to or from a device one of the following error codes is
displayed on the console.
Table 0.1:
Error
code
Message Explanation and action
1 Flash read preparation failed. A flash error occurred during the download.
Retry the download. If it fails again, contact customer support.
2Flash read failed.
3 Flash write preparation failed.
4 Flash write failed.
5 TFTP session timeout. TFTP failed because of a time out.
Check IP connectivity and make sure the TFTP server is running.