Quick Reference Guide
816 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Displaying BGP4 information
25
Syntax: [no] snmp-server enable traps bgp
Use the no form of the command to disable BGP traps.
Displaying BGP4 information
You can display the following configuration information and statistics for the BGP4 protocol on the
router:
• Summary BGP4 configuration information for the router
• Active BGP4 configuration information (the BGP4 information in the running-config)
• CPU utilization statistics
• Neighbor information
• Peer-group information
• Information about the paths from which BGP4 selects routes
• Summary BGP4 route information
• The router BGP4 route table
• Route flap dampening statistics
• Active route maps (the route map configuration information in the running-config)
Displaying summary BGP4 information
You can display the local AS number, the maximum number of routes and neighbors supported,
and some BGP4 statistics.
To view summary BGP4 information for the router, enter the following command at any CLI prompt.
This display shows the following information.
PowerConnect# show ip bgp summary
BGP4 Summary
Router ID: 101.0.0.1 Local AS Number : 4
Confederation Identifier : not configured
Confederation Peers: 4 5
Maximum Number of Paths Supported for Load Sharing : 1
Number of Neighbors Configured : 11
Number of Routes Installed : 2
Number of Routes Advertising to All Neighbors : 8
Number of Attribute Entries Installed : 6
Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend
1.2.3.4 200 ADMDN 0h44m56s 0 0 0 2
10.0.0.2 5 ADMDN 0h44m56s 0 0 0 0
10.1.0.2 5 ESTAB 0h44m56s 1 11 0 0
10.2.0.2 5 ESTAB 0h44m55s 1 0 0 0
10.3.0.2 5 ADMDN 0h25m28s 0 0 0 0
10.4.0.2 5 ADMDN 0h25m31s 0 0 0 0
10.5.0.2 5 CONN 0h 0m 8s 0 0 0 0
10.7.0.2 5 ADMDN 0h44m56s 0 0 0 0
100.0.0.1 4 ADMDN 0h44m56s 0 0 0 2
102.0.0.1 4 ADMDN 0h44m56s 0 0 0 2
150.150.150.150 0 ADMDN 0h44m56s 0 0 0 2