Quick Reference Guide

PowerConnect B-Series TI24X Configuration Guide 817
53-1002269-02
Displaying BGP4 information
25
TABLE 126 BGP4 summary information
This field... Displays...
Router ID The Layer 3 Switch router ID.
Local AS Number The BGP4 AS number the router is in.
Confederation Identifier The AS number of the confederation the Layer 3 Switch is in.
Confederation Peers The numbers of the local ASs contained in the confederation. This list matches
the confederation peer list you configure on the Layer 3 Switch.
Maximum Number of Paths
Supported for Load Sharing
The maximum number of route paths across which the device can balance traffic
to the same destination. The feature is enabled by default but the default number
of paths is 1. You can increase the number from 2 – 4 paths. Refer to “Changing
the maximum number of paths for BGP4 load sharing” on page 769.
Number of Neighbors
Configured
The number of BGP4 neighbors configured on this Layer 3 Switch.
Number of Routes Installed The number of BGP4 routes in the router BGP4 route table.
To display the BGP4 route table, refer to “Displaying the BGP4 route table” on
page 835.
Number of Routes Advertising
to All Neighbors
The total of the RtSent and RtToSend columns for all neighbors.
Number of Attribute Entries
Installed
The number of BGP4 route-attribute entries in the router route-attributes table. To
display the route-attribute table, refer to “Displaying BGP4 route-attribute entries”
on page 841.
Neighbor Address The IP addresses of this router BGP4 neighbors.
AS# The AS number.