Quick Reference Guide

954 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Displaying 802.1X information
28
To display information about the 802.1X configuration on an individual port, enter a command such
as the following.
Syntax: show dot1x config ethernet <portnum>
The <portnum> parameter is a valid port number.
The following additional information is displayed in the show dot1x config command for an
interface.
tx-period When a Client does not send back an EAP-response/identity frame, the amount
of time the Dell device waits before retransmitting the EAP-request/identity frame
to a Client (default 30 seconds).
Refer to “Setting the wait interval for EAP frame retransmissions” on page 947 for
information on how to change this setting.
supp-timeout When a Client does not respond to an EAP-request frame, the amount of time
before the Dell device retransmits the frame.
Refer to “Setting the wait interval for EAP frame retransmissions” on page 948 for
information on how to change this setting.
server-timeout When the Authentication Server does not respond to a message sent from the
Client, the amount of time before the Dell device retransmits the message.
Refer to “Specifying a timeout for retransmission of messages to the
authentication server” on page 949 for information on how to change this
setting.
max-req The number of times the Dell device retransmits an EAP-request/identity frame if
it does not receive an EAP-response/identity frame from a Client (default 2
times).
Refer to “Setting the maximum number of EAP frame retransmissions” on
page 948 for information on how to change this setting.
re-authperiod How often the device automatically re-authenticates Clients when periodic
re-authentication is enabled (default 3,600 seconds).
Refer to “Configuring periodic re-authentication” on page 946 for information on
how to change this setting.
Protocol Version The version of the 802.1X protocol in use on the device.
TABLE 146 Output from the show dot1x command (Continued)
This field... Displays...
PowerConnect# show dot1x configuration ethernet 3
Port-Control : control-auto
filter strict security : Enable
Action on RADIUS timeout : Treat as a failed authentication
re-authenticate : 150 seconds
PVID State : Normal (101)
Original PVID : 101
PVID mac total : 1
PVID mac authorized : 1
num mac sessions : 1
num mac authorized : 1
Number of Auth filter : 0