Quick Reference Guide

962 PowerConnect B-Series TI24X Configuration Guide
53-1002269-02
Displaying 802.1X information
28
Displaying information about the ports in an 802.1X multiple-host configuration
To display information about the ports in an 802.1X multiple-host configuration, enter the following
command.
PowerConnect(config-dot1x)# sh do mac-s br
Port Number of Number of Dynamic Dynamic Dynamic
users Authorized users VLAN ACL MAC-Filt
--------------------------------------------------------------------
1 0 0 no no no
2 0 0 no no no
3 0 0 no no no
4 0 0 no no no
5 0 0 no no no
6 0 0 no no no
7 0 0 no no no
8 0 0 no no no
9 0 0 no no no
10 0 0 no no no
11 0 0 no no no
12 0 0 no no no
13 0 0 no no no
14 0 0 no no no
15 0 0 no no no
16 0 0 no no no
Syntax: show dot1x mac-session brief
The following table describes the information displayed by the show dot1x mac-session brief
command.
Age The software age of the dot1x-mac-session.
PAE State The current status of the Authenticator PAE state machine. This can
be INITIALIZE, DISCONNECTED, CONNECTING,
AUTHENTICATING, AUTHENTICATED, ABORTING, HELD,
FORCE_AUTH, or FORCE_UNAUTH.
NOTE: When the Authenticator PAE state machine is in the
AUTHENTICATING state, if the reAuthenticate, eapStart, eapLogoff,
or authTimeout parameters are set to TRUE, it may place the
Authenticator PAE state machine indefinitely in the ABORTING state.
If this should happen, use the dot1x initialize command to initialize
802.1X port security on the port, or unplug the Client or hub
connected to the port, then reconnect it.
TABLE 152 Output from the show dot1x mac-session brief command
This field... Displays...
Port Information about the users connected to each port.
Number of users The number of users connected to the port.
Number of Authorized users The number of users connected to the port that have been successfully
authenticated.
TABLE 151 Output from the show dot1x mac-session command (Continued)
This field... Displays...