Installation Manual

2 Dell PowerConnect W-Series SFP | Installation Guide
SFP-TX
Table 3 describes the specifications for the SFP-TX module.
SFP-SX
Table 4 describes the specifications for the SFP-SX module.
SFP-LX
Table 5 describes the specifications for the SFP-LX module.
SFP Installation
To install an SFP module:
1. Use standard ESD precautions when installing an SFP module.
2. Slide the SFP module into a 1000Base-X port of the controller/switch until a connection is made and an
audible click is heard.
3. Lock the SFP in place by moving the latch on the module to an upright position, facing the top of the module.
Parameter Specification
Connector Type RJ-45
Cable Type and Range Cat 5, 5E, 6/Range up to 100 m
Parameter Specification
Connector Type LC fiber optic
Cable Type and Range 62.5 μm multi-mode fiber/Range up to 260 m (850 feet)
50 μm multi-mode fiber/Range up to 550 m (1800 feet)
Input Wavelength 770 to 860 nm
Center Wavelength 830 to 860 nm
Input Optical Power -17 to -3 dBm
Output Optical Power -9.5 to -4 dBm
RMS Spectral Width 850 pm
Parameter Specification
Connector Type LC fiber optic
Cable Type and Range 9 μm single-mode fiber/Range of 10 km (6.21 miles)
Input Wavelength 1260 nm to 1570 nm
Center Wavelength 1310 nm
Input Optical Power -20 to -3 dBm
Output Optical Power -9.5 to -3 dBm
RMS Spectral Width 4 nm