Users Guide

Information Update 1-5
System Message Update
The system messages shown in Table 1-1 have been added or updated.
Table 1-1. System Messages
Message Causes Corrective Actions
Caution! NVRAM_CLR
jumper is installed on
system board - please
run SETUP program.
NVRAM_CLR jumper is
installed.
Remove the NVRAM_CLR
jumper. See Figure A-2 in the
Installation and Troubleshooting
Guide for jumper location.
Invalid configuration
information - please
run SETUP program.
Invalid configuration settings in
the System Setup program, or
the system battery is faulty.
Check the System Setup
configuration settings. See
"Using the System Setup
Program" in your User’s Guide.
Replace the battery. See
"Replacing the System Battery"
in the Installation and
Troubleshooting Guide.
This processor system
bus speed is unknown.
System halted!
The installed processor is not
supported by the system.
Reboot the system. If you
receive beep code 4-4-3
(processor frequency mismatch),
replace the installed processor(s)
with processor(s) supported by
your system. See "Processors" in
the Installation and
Troubleshooting Guide.
If a beep code does not occur at
system boot, turn off the system,
install the NVRAM_CLR
jumper, and reboot the system.
See Figure 5-2 in the Installation
and Troubleshooting Guide for
jumper locations.
H0544ebk5.book Page 5 Tuesday, July 8, 2003 9:14 AM