Installation and Troubleshooting Guide


2. Unless you are installing a hot-plug component such as a cooling fan or hot-plug expansion card, turn off the system and attached peripherals, and
disconnect the system from the electrical outlet and peripherals.

3. To remove the system cover, loosen the two captive screws at the front of the system. See Figure5-3.

4. Slide the cover backward about 1.3 cm (0.5 inch), and grasp the cover on both sides.

5. Carefully lift the cover away from the system.
Figure 5-3. Installing and Removing the System Cover
Closing the System

1. Ensure that you did not leave tools or loose parts inside the system.

2. Place the cover over the sides of the chassis, and slide the cover forward.

3. Tighten the two captive screws at the front of the system to secure the cover. See Figure5-3.

4. Reconnect the peripheral cables.