Installation and Troubleshooting Guide


Installing a Power Supply

1. Holding the lever in the open position, slide the new power supply into the chassis until the lever contacts the system chassis. See Figure6-5.

2. Close the lever until the power supply is fully seated and the lever snaps behind the lever release latch. See Figure6-5.

3. Connect the power cable to the power supply and plug the cable into a power outlet.
After installing a new power supply, allow several seconds for the system to recognize the power supply and determine whether it is working properly. The
power-on indicator will turn green to signify that the power supply is functioning properly (see Figure2-4).
Expansion Cards
Your system supports up to seven full-length expansion cards installed in connectors on the system board. See Figure6-6 for the locations of the connectors.
The expansion slots are configured as follows:
¡ Slot 1 is a hot-plug, x8 lane-width PCI-Express expansion slot.
¡ Slot 2 is a hot-plug, 3.3-V, 64-bit, 133-MHz PCI-X expansion slot.
¡ Slots 3 through 5 are hot-plug, x4 lane-width PCI-Express expansion slots.
¡ Slots 6 and 7 are non–hot-plug, 3.3-V, 64-bit, 100-MHz PCI-X expansion slots.
Figure 6-6. Expansion Slots
NOTE: If you unlatched the cable management arm in step 3 of the previous procedure, relatch it. For information about the cable management
arm, see the system's Rack Installation Guide.
NOTICE: When connecting the power cable, insert the cable through the strain-relief loop.
NOTE: If you are installing a Remote Access Control (RAC) card, it must be installed in card slot 7 to enable it to be cabled to the RAC connector on
the system board. See FigureA-3 for the location of the RAC connector.
NOTE: Slot 7 supports full-height, half-length cards only.
NOTE: The system board also provides a proprietary connector for an optional non–hot-plug Fibre Channel module card. Do not use that
connector for any other card other than the Fibre Channel module card. See "Integrated Fibre Channel Module Card" for more information about
the connector.