Users Guide

FlexAddress
Feature State in
CMC
IO Identity Feature
State in iDRAC
Availability of
Remote Agent VA
for the Reboot
Cycle
VA Programming
Source
Reboot Cycle VA
Persistence
Behavior
Server with VAM
Persistence Policy
Feature
Enabled Disabled FlexAddress from
CMC
Per FlexAddress
spec
Enabled Enabled Yes — New or
Persisted
Remote Agent
Virtual Address
Per Remote Agent
Policy Setting
No FlexAddress from
CMC
Per FlexAddress
spec
Disabled Enabled Yes — New or
Persisted
Remote Agent
Virtual Address
Per Remote Agent
Policy Setting
No Virtual Address
Cleared
Disabled Disabled
Enabling or disabling I/O Identity Optimization
Normally, after the system boots, the devices are configured and then after a reboot the devices are initialized. You can enable the
I/O Identity Optimization feature to achieve boot optimization. If it is enabled, it sets the virtual address, initiator, and storage target
attributes after the device is reset and before it is initialized, thus eliminating a second BIOS restart. The device configuration and
boot operation occur in a single system start and is optimized for boot time performance.
Before enabling I/O identity optimization, make sure that:
• You have the Login, Configure, and System Control privileges.
• BIOS, iDRAC, and network cards are updated to the latest firmware. For information on the supported versions, see Supported
cards for I/O Identity Optimization and Supported nic firmware version for i/o identity optimization.
After enabling I/O Identity Optimization feature, export the XML configuration file from iDRAC, modify the required I/O Identity
attributes in the XML configuration file, and import the file back to iDRAC.
For the list of I/O Identity Optimization attributes that you can modify in the XML configuration file, see the NIC Profile document
available at delltechcenter.com/idrac.
NOTE: Do not modify non I/O Identity Optimization attributes.
Enabling or disabling I/O Identity Optimization using web interface
To enable or disable I/O Identity Optimization:
1. In the iDRAC Web interface, go to Overview → Hardware → Network Devices.
The Network Devices page is displayed.
2. Click the I/O Identity Optimization tab, select the I/O Identity Optimization option to enable this feature. To disable, clear
this option.
3. Click Apply to apply the setting.
Enabling or disabling I/O Identity Optimization using RACADM
To enable I/O Identity Optimization, use the command:
racadm set idrac.ioidopt.IOIDOptEnable Enabled
After enabling this feature, you must restart the system for the settings to take effect.
To disable I/O Identity Optimization, use the command:
racadm set idrac.ioidopt.IOIDOptEnable Disabled
To view the I/O Identity Optimization setting, use the command:
racadm get iDRAC.IOIDOpt
168