Users Guide

5. Enter the backup file name and encryption passphrase (optional).

6. If Network is selected as the file location, enter the network settings.

NOTE: While specifying the network share settings, it is recommended to avoid special characters for user name

and password or percent encode the special characters.

For information about the fields, see the iDRAC Online Help

7. In the Backup Window Schedule section, specify the backup operation start time and frequency of the operation (daily,

weekly, or monthly).

For information about the fields, see the iDRAC Online Help.

8. Click Schedule Backup.

A recurring job is represented in the job queue with a start date and time of the next scheduled backup operation. Five minutes

after the first instance of the recurring job starts, the job for the next time period is created. The backup server profile

operation is performed at the scheduled date and time.

Scheduling automatic backup server profile using RACADM

To enable automatic backup use the command:

racadm set lifecyclecontroller.lcattributes.autobackup Enabled

To schedule a backup server profile operation:

racadm systemconfig backup –f <filename> <target> [-n <passphrase>] -time <hh:mm> -dom

<1-28,L,’*’> -dow<*,Sun-Sat> -wom <1-4, L,’*’> -rp <1-366>-mb <Max Backups>

To view the current backup schedule:

racadm systemconfig getbackupscheduler

To disable automatic backup use the command:

racadm set LifeCycleController.lcattributes.autobackup Disabled

To clear the backup schedule:

racadm systemconfig clearbackupscheduler

For more information, see the iDRAC RACADM Command Line Interface Reference Guide available at dell.com/idracmanuals.

Importing server profile

You can use the backup image file to import or restore the configuration and firmware for the same server without rebooting the

server.

Import feature is not licensed.

NOTE: For the restore operation, the system Service Tag and the Service Tag in the backup file must be identical. The

restore operation applies to all system components that are same and present in the same location or slot as captured in

the backup file. If components are different or not in the same location, they are not modified and restore failures is

logged to the Lifecycle Log.

Before performing an import operation, make sure that Lifecycle Controller is enabled. If Lifecycle Controller is disabled, and if you

initiate the import operation, the following message is displayed:

Lifecycle Controller is not enabled, cannot create Configuration job.

When the import is in-progress, if you initiate an import operation again, the following error message is displayed:

Restore is already running

Import events are recorded in the Lifecycle Log.

Easy Restore

NOTE: Easy Restore is available only on 13

generation PowerEdge servers that have the Easy Restore flash memory.

Easy Restore is not available on PowerEdge R930.